Materials Needed & Measurements:
- Yarn: 3 skeins of Bernat Blanket Extra Thick in Vintage White (600g/21.2 oz, 66m/72 yds)
- Hook: 25mm crochet hook
- Scissors: For trimming yarn
- Dimensions: 44″ x 36″
- Gauge: 4″ = 3 stitches, 2 rows
Abbreviations:
- ch = chain
- st = stitch
- sl st = slip stitch
- sc = single crochet
- hdc = half double crochet
- dc = double crochet
Stitching Instructions for Making Crochet Extra Thick and Creamy Throw Pattern:
Foundation Chain and Starting Rows:
- Foundation Chain: Ch 42 (or any multiple of 3). This will determine the width of your throw. For a wider blanket, increase the foundation chain accordingly. Each chain is roughly 1 inch, so adjust to suit your desired width (44 inches is typical for a throw).
- Row 1:
- In the 3rd ch from the hook, work 1 dc. This marks the start of the pattern and establishes the first double crochet.
- Work 1 dc in each ch across the row, making sure to stitch into each chain.
- Turn the work around.
- Row 2:
- Ch 2 (this counts as the first dc in the row).
- Work dc in each st across the row. The ch-2 at the beginning of the row counts as the first dc.
- Turn your work.
Creating the Textured Pattern:
- Row 3 (Single Crochet Row):
- Ch 1 (this counts as your first sc).
- Work sc in each st across the row. The single crochet creates a subtle texture to contrast with the double crochet rows.
- Turn your work.
- Row 4 (Half Double Crochet Row):
- Ch 2 (this counts as your first hdc).
- Work hdc in each st across the row. The half double crochet gives a slightly taller stitch than the single crochet, adding to the texture of the throw.
- Turn your work.
- Row 5 (Double Crochet Row):
- Ch 2 (this counts as your first dc).
- Work dc in each st across the row.
- Turn your work.
- Row 6 (Single Crochet Row):
- Ch 1 (this counts as your first sc).
- Work sc in each st across the row.
- Turn your work.
- Row 7 (Half Double Crochet Row):
- Ch 2 (this counts as your first hdc).
- Work hdc in each st across the row.
- Turn your work.
Repeating the Pattern:
- Repeat Rows 2-7:
- Continue repeating Rows 2 through 7 until your throw reaches the desired length, usually around 36″ (or adjust to any length you like).
- The pattern alternates between dc, sc, and hdc rows, which adds a chunky, textured effect to the blanket.
- Tip: Each time you complete a set of rows (dc, sc, hdc), the texture will begin to show, with alternating heights of stitches creating a beautiful, thick fabric.
Finishing the Throw:
- Final Row:
- When you reach the final row, work a sc row (Row 6) or hdc row (Row 7) for the edge, depending on your preference for the last row’s texture.
- After completing the last row, sl st into the first stitch of the row to close it.
- Cut the yarn, leaving a generous length to weave in the ends. Pull the yarn through the final loop to fasten it securely.
- Weaving in Ends: Use your yarn needle to weave in any loose ends from the foundation chain and the last row. Make sure to thread the yarn through multiple stitches to ensure it is securely fastened.
- Trim Any Excess Yarn: After weaving in the ends, trim off any excess yarn to finish the blanket neatly.
